**READY TO SHIP** These are precision, handmade wax pump injectors, made of aluminum, brass, and stainless steel. The valve body consists of two (2) small stainless steel ball valves for easy pumping of warm melted wax. Made to drop into a shallow container of melted low-temp wax for injecting small jewelry and figurines, silicone, and other types of molds.
No air compressor needed. Manual, easy, full control of mold injections.
NOTE: Only Pump Included In Sale. No Pot Included. Just for example usage only!!!
Dimensions:
7-1/4 inch tall - from bottom of base to top of push/pull knob.
5-3/4 inch tall - from the bottom base to the top tip. May vary a tiny bit.
3 inches wide - from side to side of the base.
1 inch wide - the pump is a 1-inch OD aluminum tube.
Handcrafted by a Hobby Craftsman. Made for jewelry makers and all lost wax metal casting.
Get yours while they last. It took way too long in time and effort to make these. I don't know if I'll be able to make more. Very hard to make the pump valve body. Very small and precise craftsmanship is needed to make.
Mine works great, hope you enjoy yours.
Thanks for looking. Don't forget to bookmark it for later.
Rick.
Shipping will be same day if ordered early, the next day if not.
Thanks, Rick.